Konica Minolta Polygon Editing Tool - Manual (Page 196)

194
Chapter
2
Build
Menu
9i
910
900
700
300
n Extracting a Face
Extract a face from the selected points as explained below.
Operating Procedure The following steps must be carried out in Build – Move – To X-Y-Z mode.
Parameters for [Select Face Attribute] Dialog Box
XY-Plane Generates a XY plane based on the selected points.
YZ-Plane Generates a YZ plane based on the selected points.
ZX-Plane Generates a ZX plane based on the selected points.
1 Select the desired points.
M
emo
• Select the points using the Select and View menu com-
mands.
• After operation, please cancel the Select or View menu
command.
2 Click the right mouse button.
The [Select Face Attribute] dialog box will ap-
pear.
3 Select the desired face attribute from
the pull-down menu.
When the selected attribute of the face is “XY-
Plane”, Z-Axis is made in agreement with the
face normal.
But the direction of the axis is calculated by
the algorithm. If the direction is not suitable,
click the [Reverse] button in [Confirmation(for
coordinate)] dialog box to reverse the axis
direction.
4 Click the [OK] button.
The generated face will be displayed, and the
[Confirmation] dialog box will appear.
5 Click the [OK] button.
Proceed to the extraction procedure for the
next element (point or line).
Build – Move – To X-Y-Z