Konica Minolta Polygon Editing Tool - Manual (Page 197)

195
Chapter
2
Build
Menu
9i
910
900
700
300
n Extracting a Point
Extract a point from the selected points as explained below.
Operating Procedure The following steps must be carried out in Build – Move – To X-Y-Z mode.
1 Select the desired points.
M
emo
• Select the points using the Select and View menu com-
mands.
• After operation, please cancel the Select or View menu
command.
2 Click the right mouse button.
The [Select Point Type] dialog box will appear.
3 Select the desired point type from the
pull-down menu.
4 Click the [OK] button.
The [Input XYZ Value] dialog box will appear.
5 Enter the design values for the point.
M
emo
For certain types of extraction, you will only be able to
enter values for two of three axes. For instance, if XY-
Plane is selected, the text box for Z value will be inactive
since it is not necessary to enter the Z-coordinate value.
6 Click the [OK] button.
The generated point will be displayed, and the
[Confirmation] dialog box will appear.
Build – Move – To X-Y-Z