Kamera Werk Dresden CMOS - Manual (Page 11)

Manual: CMOS Industrial Camera LOGLUX

i5 Version 1.08 (04/07)

KAMERA WERK DRESDEN GmbH Page 11 of 46
If no difficulties occurred during installation, the CameraLink ™ MVtitan-CL PC plug-in card is properly
installed.
Note: In general, no re-registration with Microsoft

, the maker of the Windows

operating system,
(Microsoft

safety system) will be necessary. Please make sure you use drivers certified by Microsoft

where possible. See also the information of the plug-in card manufacturer.
Installation of the CMOS industrial camera LOGLUX

i5 CL
Once the CameraLink
™
(see above) has been properly installed, the installation of the CMOS
industrial camera LOGLUX

i5 CL is very easy.
First mount the CMOS industrial camera LOGLUX

i5 CL in a safe and stable manner. Use the slot on
the bottom of the camera housing and the associated keys for the purpose, where possible, as these
allow safe fastening to various modular design systems having fitting counterparts.
Once the CMOS industrial camera LOGLUX

i5 CL has been safely mounted, connect the cables to
the host system (PC or IPC).
For the purpose, plug the properly laid
customized
data cables into the
corresponding electrical/mechanical
connectors on the camera and into the
CameraLink
™
MVtitan-CL PC plug-in
card of the PC or IPC. Then connect the
split adapter (Fig. 7) to the 9-pole D-
SUB connector on the camera and
power supply unit (plug-type or DIN/EN
bus-bar
power supply unit).
Furthermore, you may use the split
adapter to link the camera up with an
optional triggering system, e.g. the
switching output of a light barrier, in
order to trigger the framegrabbing
process in an event-controlled mode. The same plug connector is provided with two additional
switching outputs.
Once the plug connectors and data cables have been safely connected, the operating voltage (24 V
±
10%) can be applied to the camera.
Caution: Always use the plug-type power supply unit supplied with the CMOS industrial camera
LOGLUX

i5 CL SET, or DIN bus-bar type 24V power supply units which are suitable for
industrial control systems (PLCs)! Always connect the camera to a separate power supply!
Readiness for operation is indicated by the continuously lit green status LED on the rear of the CMOS
industrial camera LOGLUX

i5 CL.
The CMOS industrial camera LOGLUX

i5 CL is now ready for operation. The next step is the
installation of the ‚LOGLUX

LuxWare‘ configuration tool.
Installation of the LOGLUX

LuxWare configuration tool
Once the CMOS industrial camera LOGLUX

i5 CL has been properly prepared, the installation of the
LOGLUX

LuxWare is very easy.
After booting the PC and logging into the Windows

operating system as administrator, the LOGLUX

LuxWare software is automatically started after insertion of the CD ROM if you have activated the auto
CD ROM start option on your computer.
If not, start ‚Setup.exe‘ in the main directory of the CD ROM manually.
In both cases, follow the instructions given by the installation software.
⇐ to camera
D-SUB 9-pole
RS-232 D-SUB 9-pole
to PC/IPC
⇒
to power supply ⇒
2-pole connector
Trigger inputs/
switching outputs
⇒
4-pole connector
Figure 8 : View of a split cable