Kamera Werk Dresden CMOS - Manual (Page 30)

Version 1.08 (04/07) Manual: CMOS Industrial Camera LOGLUX

i5

Page 30 of 46 KAMERA WERK DRESDEN GmbH
CONFIG_EOLTYPE The register specifies the end-of-line characters to be sent. The control
character for carriage return (CR), new line (NL) or a combination thereof can
be chosen.
Example: w $03 #0 ;line break character CR+NL
CONFIG_VERIFY The register specifies the initiation of the camera-internal hardware check.
Example: w $07 $00 ;no hardware write check
CONFIG_MSGMASK The register specifies the scope of messages to be output. This filter may be
advantageously used for function verifications or debugging.
Example: w $08 $F0 ;show all errors only
CONFIG_PROFILE The register specifies the working profile of the sensor. A write access
immediately results in the sensor being set to the parameters of the given
working profile.
Example: w $09 #1 ;working profile is profile 1
CONFIG_DESCRIPTION
The register contains a string of 32 ASCII characters that identify the camera.
The default setting is ‚Camera SN 630 xxx‘ (camera serial number).
Function group ‚Camera profiles‘
This function group is used for setting the parameters of the four selectable camera sensor profiles,
the parameters being the pixel clock rate, snapshot mode, trigger rate, trigger mode, video mode,
look-up table used, region of interest, integration time modes (multiple slope mode settings), shutter
mode and line and/or column subsampling.
The camera profiles are located in the following register address ranges:
Register address range Content of register address range
$100 ... $1FF Camera profile 1
$200 ... $2FF Camera profile 2
$300 ... $3FF Camera profile 3
$400 ... $4FF Camera profile 4
As an example for camera profile 1, the following table shows all registers of this function group (for
the other camera profiles: same register names, but different register address range):
Register Addr. Format Description Value range Meaning Default
PROFILE_PIXELCLK $102 1 long Pixel clock rate 20 7 ... 4 . 10 7 Pixel clock rate in [Hz]
PROFILE_TRGSOURCE $103 1 byte Trigger source 0
1
2
3
4
5 no trigger
trigger on H/L slope
trigger on L/H slope
L/H slope on CC1
trigger via T-register
Free running trigger
PROFILE_TRGDELAY $104 1 long Trigger delay 0 ... 2 32 delay time in [ns]
PROFILE_TRGRATE $108 1 word Trigger rate 1 ... 6500 trigger rate in [Hz]
PROFILE_SMODE $10A 1 word Snapshot mode 0
1
2 ... 65535
sequence mode
single snapshot
continuous mode
See table
‚Initial values
of profile
registers‘
Continued on next page ...