Kamera Werk Dresden CMOS - Manual (Page 40)

Version 1.08 (04/07) Manual: CMOS Industrial Camera LOGLUX

i5

Page 40 of 46 KAMERA WERK DRESDEN GmbH
Technical specification
Technical data of the LOGLUX i5 CL (survey)
Sensor format: 1280 x 1024 pixels
(
2 /
3
in. sensor diagonal)
freely selectable ROI
Pixel size: 6.7 x 6.7
µ
m 2
ADC resolution: 10 bit greyscale value
Image transfer Resolution fps
rate: 1280 x 1024 36
1024 x 768
58
320 x 240 445
Shutter modes: rolling shutter
central shutter
Dynamic range: 64 dB linear,
> 100 dB in multiple
integration slope mode
FPN: < 0.2% RMS
Sensitivity: 8.46 V/(lx . s)
in visible light and NIR
range (70 lx = 1 W/m 2 )
S/N ratio: 1600 : 1
Spectral range : 400...1000 nm
Configuration: - 4 user-programmable camera profiles
- bootable with initial settings
Integral functions: test image, three user-program-
mable
LUTs, optional: target
graticule, pixel binning, real-time
matrix operations, etc.
Interfaces: - CameraLink ™ (base)
- RS-232 115kbaud, electrically
isolated
- one 24VDC trigger port, electrically
isolated
- two 24VDC/max. 500mA
switchports (low-side switch),
electrically isolated
Power supply: 18...35 VDC
Power loss: <2 W
Temp. range: 0...60°C (operation)
Dimensions HxWxD 54 x 46 x 82
(mm/without lens):
Lens mount: C mount
Weight: approx. 250g (without lens)
Scope of delivery: camera with LuxWare software and
manual (on CD-ROM)
Pin assignments of the LOGLUX
®
i5 CL
The mechanical and electrical parameters of the CameraLink™ connector ('DIGITAL OUT')
correspond to the CameraLink™ standard specifications. More information can be found in the
following documents and under
www.ieee.org :
•
CameraLink™ Interface Standard Specification, Technical Communications, October 2000
•
CameraLink™ Technology Brief, Basler Vision Technologies, March 2001
Assignment of pins of the 9-pole support connector ('COM / POWER / TRIG'):
Front view
Fitting female connector (example):
product name: JEZ-9S made by JST
Pin
no.
Signal name Function
1 +24V 24V power supply
2 Rx Serial reception
3 Tx Serial transmission
4 GND_pwr Central ground (power
supply)
5 GND_if Serial signal ground
6 Ext_Trig_in Trigger signal input
7 GND_pwr Central ground (trig./SW)
8 Ext_SW_out1 1st switch signal output
9 Ext_SW_out2 2nd switch signal output
Pin assignment of the split cable for the LOGLUX
®
i5 CL
Power supply: Binder 2-pin conn.
→
Binder 2-pin female c. type 712 (Order no. 99-0402-00-02)
Pin 1: +24VDC Pin 2: GND
Trigger input/
switch outputs:
Binder 4-pin conn.
→
Binder 4-pin female c. type 712 (Order no. 99-0410-00-04)
Pin 1: Trigger input Pin 2: Switchport 0 Pin 3: Switchport 1 Pin 4 : GND