Konica Minolta Network Printer - Manual (Page 102)

Loading Paper (continued)
8-4 Maintenance & Supplies
Maintenance & Supplies
Loading Paper in Tray 3
When Thick or Thin is displayed on the tray key of the Basic Screen, be sure to load the
specified paper; otherwise mishandled paper may occur.
When TAB is displayed on the tray key of the Basic Screen, see p. 8-7.
1 Withdraw tray 3, and open the paper feed roller.
2 Place some paper in the tray with the curl side turning up.
Load size 11"x17", 8.5"x14", 8.5"x11", 8.5"x11"R or 5.5"x8.5" (user-adjustable)
3 Move the green lever (located at the left side) of the rear paper guide to the edge of the
paper.
NOTES: • Do not hold the upper part of the rear and front paper guides to move them, otherwise they may be
damaged.
• Be sure that the paper guides are securely aligned to the paper; otherwise the machine cannot detect
the correct paper size, and prints may not be punched in position.
4 Add paper in the tray.
Do not stack paper above the thick red line.
5 When paper is seated properly, close the paper feed roller.
6 Push the tray back fully into the printer.
NOTE: Do not bump the tray into the main body; otherwise machine trouble may be caused.
HOME