Konica Minolta Network Printer - Manual (Page 105)

Maintenance & Supplies 8-7
Maintenance & Supplies
Loading Paper (continued)
Loading Tabbed Sheets in Tray 1, 2, or 3
Load offset tabbed sheets so that the tab extensions are on the left at the rear (not front) of
the tray. The tab extension width should be 0.5" (12.5 mm) or less.
When loading tabbed sheets in the tray, be sure to specify the paper type as TAB in the
Key Operator mode; otherwise mishandled paper may occur.
The top sheet is designated face down as the first tab of the finished set. Subsequent
offset tab sheets follow in sequence.
Section 3
Management Section 3
Management Section 3
Management
Section 3
Management
Section 1
Introduction
Section 1
Introduction
Section 1
Introduction
Section 1
Introduction
ONE FINISHED SET
THREE FINISHED SETS
Example: 3 Tabbed sheets loaded in position for one finished set.
Example: 9 Tabbed sheets loaded in position for 3 finished sets.
Printed
side
1st TAB
1st TAB
1st TAB
1st TAB
2nd TAB
2nd TAB
2nd TAB
2nd TAB
3rd TAB
3rd TAB
3rd TAB
3rd TAB
Rear
Front
Rear
Front
HOME