Konica Minolta Network Printer - Manual (Page 20)

2-6 Safety Information
Safety Information
Machine Installation and Power Requirements
CAUTION:
FAILURE TO HEED THE FOLLOWING CAUTIONS MAY RESULT IN BODILY INJURY AND/OR
MACHINE DAMAGE.
❒ FIRE PREVENTION
Install machine away from flammable or volatile materials. Routinely check for abnormal
heat from power cord and/or plug.
❒ SHORT CIRCUIT FROM WATER DAMAGE
Do not install or operate this equipment outdoors near a lake, pond, or river, etc.; and do
not allow the machine to come in contact with splashes of rain, water, or any liquid.
❒ TEMPERATURE AND HUMIDITY
Install the machine away from direct sunlight, heat sources
(stoves, heaters) and cold temperatures (air conditioners).
Avoid any environment that is outside 50°~86°F (10°~30°C),
with 10~80% humidity.
❒ VENTILATION
Do not allow the machine to come in contact with dust or
ammonia gas, or fumes from printing or cleaning solutions, etc.;
otherwise, image quality will be poor. Install the machine in a
well-ventilated area, for comfort; otherwise, an ozone odor will
be detected during large print runs. When in use, the printer
generates ozone in amounts too small to be hazardous to the
human body.
❒ VIBRATIONS
If the machine is constantly vibrated or jolted, trouble may
occur. Install the machine on a level, horizontal floor, free from
vibrations.
❒ SPACE ALLOTMENT
Install machine in an area with adequate space for performing printer operations, replacing
supply items, and conducting preventive maintenance. See Site Requirements, Section 3.
❒ MACHINE RELOCATION/TRANSPORTATION
Be sure to contact your service representative when moving or transporting the machine.
If you move the machine with the Memory unit installed, machine trouble may be caused
by vibration.
Temperature
Vibration
HOME