Konica Minolta Network Printer - Manual (Page 78)

6-2 Output Modes
Output Modes
FS-110/210 Finisher Specifications
Use only paper that is recommended by Konica and stored under the environmental
conditions stated for print quality. Special stock is not guaranteed for reliability or print quality.
This Finisher also accommodates wide paper sizes in addition to the standard sizes
described below. See p. 4-5 ~ p. 4-7 for details.
Finisher Type
❒ Primary (Main) Tray with built-in 2 stapling: moving tray type
Secondary (Sub) Tray
Booklet Tray (FS-210 Finisher only)
Cover Sheet Feeder PI-110 (option)
Punching Kit PK-110/120 (option)
Punching / Z-Folding Unit PZ-108 (option)
Primary (Main) Tray
• Non-Sort Mode
❒ Paper size: 11"x17"~5.5"x8.5"
❒ Paper weight: 16~24 lb; Special stock (65 lb (176 g/m
2 cover paper), transparency film, labels,
hole punch, rag content)
❒ Paper capacity for 20 lb: 500 sheets 5.5"x8.5"
3,000 sheets 8.5"x11", 8.5"x11"R (FS-110)
2,500 sheets 8.5"x11, 8.5"x11"R (FS-210)
1,500 sheets 11"x17", 8.5"x14"
• Sort Mode/Group Mode
❒ Paper size: 11"x17"~5.5"x8.5"
❒ Paper weight: 16~24 lb
❒ Paper capacity for 20 lb: 500 sheets 5.5"x8.5"
3,000 sheets 8.5"x11", 8.5"x11"R (FS-110)
2,500 sheets 8.5"x11, 8.5"x11"R (FS-210)
1,500 sheets 11"x17", 8.5"x14"
• Staple-Sort Mode
❒ Paper size: 11"x17", 8.5"x14", 8.5"x11"R, 8.5"x11" (5.5"x8.5" is available in portrait orientation
only.)
❒ Paper weight: 16~24 lb
NOTE: Using excessively curled paper or some types of thin paper in Staple-sort mode may cause poor results
in arrangement of the stapled sets.
❒ Paper capacity for 20 lb: 1,000 sheets *1
❒ Staple capacity: 50 sheets *2 (5.0 mm thick or less)
❒ Staple position: See p. 6-7.
• Z-Folding Mode: See p. 6-4
NOTES: *1: Variable according to the number of pages to be stapled. See p. 4-5 for details.
*2: Staple sheet capacity is changeable, and may be set to 45, 40 or 35 by your service representative.
HOME