Konica Minolta Network Printer - Manual (Page 91)

Output Modes 6-15
Output Modes
Manual Finishing (continued)
1 Place a set of paper to be finished into the lower
tray of the cover sheet feeder, as described below
for each mode, then align the guide plate. The
indicator light of Start/Stop button will turn green.
• 1 oblique staple / 2 parallel staples: FACE UP
• Punch: FACE UP
• Stapling & Folding: FACE UP for the outside of
the finished set
• Three-Folding: FACE UP for the outside of the
folded set
NOTE: Refer to the specifications on previous page for available
paper size and capacity in each mode.
2 Press Staple Mode Selection button and/or Punch button to select the desired mode.
NOTE: Punch mode is compatible with 1 oblique staple, 2 parallel staples, or Stapling & Folding mode.
3 Press Start/Stop button.
Finished sheets will be delivered to the appropriate tray according to the selected mode.
NOTE: If you want to stop the Manual Finishing operation, press the Start/Stop button again. The finisher will
cease operating. When using Stapling & Folding mode, the unfinished set will be left in the stacker unit
inside the finisher.
Guide plate
Lower
tray
CAUTION
When the Booklet tray capacity is exceeded, the finisher will cease operating. To avoid this, select the
appropriate print quantity from the specifications on p. 6-8.
CAUTION:
When the selected print quantity exceeds the Finisher’s maximum capacity, remove the printed sheets
while paper is exiting to avoid paper mishandling.
You may also ask your service representative to set the printer to stop printing when the established
capacity is exceeded.
HOME