Lenovo THINKSERVER 3821 User Manual
Page 109
Table 4. DSA messages (continued)
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved.
v
See Chapter 8, “Parts Listing, TD200x Machine Types 3719, 3821, 3822, and 3823,” on page 237 to determine which
components are customer replaceable units (CRU) and which components are field replaceable units (FRU).
v
If an action step is preceded by “(Trained service technician only),” that step must be performed only by a Trained
service technician.
Message
number
Component
Test
State
Description
Action
166-816-xxx
IMM
IMM I2C Test
Aborted
IMM I2C test
stopped: the
command is
illegal for the
specified
sensor or
record type.
1. Turn off the system and disconnect it from the
power source. You must disconnect the system
from ac power to reset the IMM.
2. After 45 seconds, reconnect the system to the
power source and turn on the system.
3. Run the test again.
4. Make sure that the DSA code is at the latest
level.
5. Make sure that the IMM firmware is at the latest
level. The installed firmware level is shown in
the DSA log in the Firmware/VPD section for
this component. For more information, see
“Updating the firmware” on page 267.
6. Run the test again.
7. If the failure remains, go to the Lenovo Web site
for more troubleshooting information at
166-817-xxx
IMM
IMM I2C Test
Aborted
IMM I2C test
stopped: a
command
response could
not be
provided.
1. Turn off the system and disconnect it from the
power source. You must disconnect the system
from ac power to reset the IMM.
2. After 45 seconds, reconnect the system to the
power source and turn on the system.
3. Run the test again.
4. Make sure that the DSA code is at the latest
level.
5. Make sure that the IMM firmware is at the latest
level. The installed firmware level is shown in
the DSA log in the Firmware/VPD section for
this component. For more information, see
“Updating the firmware” on page 267.
6. Run the test again.
7. If the failure remains, go to the Lenovo Web site
for more troubleshooting information at
Chapter 5. Diagnostics
101