Lanier DIGITAL COLOR PRINTER/COPIER 5722 - Manual (Page 8)

5
PREFACE CONTENTS PRECAUTIONS
PRECAUTIONS
1. INSTALLATION
The copier should be located near a wall outlet which should be easily accessible.
3
2
1 The FC22 should be installed by a qualified service technician.
Note: The packing material should be disposed of properly.
To obtain the best possible results, this copier should be used in conjunction with a
dedicated AC power line at the following ratings:
115 V–60 Hz, 16 A
Notes:
1. The use of other appliances or other equipment on the same line as this copier may adversely
affect performance and copy quality.
2. Be sure to use a 3-conductor, grounded wall outlet.
3. In areas where a 2-pin plug is used, the copier must be grounded for safety.
Never ground it to a gas pipe, a water pipe, or any other object not suitable for grounding.
After a suitable place has been selected for the installation for the FC22, please do not
change it. Avoid excessive heat, dust, vibration and direct sunlight. Also, provide
proper ventilation as the copier emits a slight amount of ozone.
Notes:
1. Recommended environmental range for use is as follows:
• Temperature: 10~30؇C/50~86ЊF
• Humidity: 20~80%RH
2. To insure optimal operation, allow clearances of at least 32" on the left, 32" on the right and
4" in the rear.
4 inches 32 inches
32 inches