Lanier DIGITAL COLOR PRINTER/COPIER 5722 - Manual (Page 88)

85
USING THE EDITING FUNCTIONS
4
3 Specify the area of the original.
(To display the screen on the right, follow steps
1-3 in the "Procedure" below.)
● Key in the value X1 using the digital keys and
press the upper SET key. If you key in a
wrong value, press the RESET key.
● Values X2, Y1 and Y2 require the same
procedure as X1.
Press the lower SET key.
2
1
Procedure
3
Using the original scale and the rear scale,
specify the values defining the desired area
as follows:
● X1 • • Distance from the original scale to the
left edge of the specified area
● X2 • • Distance from the original scale to the
right edge of the specified area
● Y1 • • Distance from the rear scale to the
upper edge of the specified area
● Y2 • • Distance from the rear scale to the
lower edge of the specified area
Press the EDIT key to enter the Editing
menu, and then press the Next key.
Press the TRIM or MASK key.
2 Press the EDITING key.
Place the original face up on the glass with
its bottom towards you and its top left
aligned against the top left of the glass.
4
Tip: Only the standard size originals are
available for this mode.