LSI 7202CP - Manual (Page 10)

1-2 Installing/Extracting the LSI7202CP Host Adapter
Copyright © 2001, 2002 by LSI Logic Corporation. All rights reserved.
1.1.2 Hot Installation Preparation
Refer to your system’s hardware user’s manual for complete instructions
regarding hot installation.
1.1.3 Installation
Review your system’s documentation for the complete instructions before
performing the following steps to install the LSI7202CP into your system:
Step 1. Identify the slot number where you want to insert the adapter.
Step 2. Refer to the system’s documentation for instructions on how to
remove the filler panel.
Step 3. Remove the filler panel from the slot you selected.
Step 4. Push on the red release button and open the LSI7202CP card’s
ejection lever before installing the card in the system.
Step 5. Pull back the ejection lever and slide the card into the
CompactPCI slot.
Step 6. Apply even pressure at both corners of the card and push the
card until it is firmly seated in the slot.
Step 7. Push the ejection lever over the sprocket toward the card and
into the locked position. This locks the card into the slot.
Step 8. Use a Phillips screwdriver to tighten the captive screws inside
the card’s ejection lever.
Step 9. Attach the Fibre Channel cable to either Port 0 or Port 1 of the
LSI7202CP. This completes the hardware installation.
Important: Check your system’s documentation for any additional
actions that may be required to configure the system soft-
ware for the newly inserted card.