LSI 7202CP User Manual
Page 39
itmpt Device Driver
4-7
Copyright © 2001, 2002 by LSI Logic Corporation. All rights reserved.
4.3.1.2 Network Installation Procedure
If you are using your LSI Logic adapter to support your Sparc Solaris
system disk, you must install the Solaris operating system using a
network install. This section describes a complete installation of the
Solaris operating system to a client system using LSI Logic adapters for
the system disk. The method described in this section allows you to
install the LSI Logic itmpt driver onto a network boot kit, making it
available during the Sparc installation process.
If you are simply installing an LSI Logic adapter as an additional storage
adapter in an existing system, use the driver installation procedure
described in the “Distribution File Install” portion of
“Existing System Installation.”
Setting up a Boot/Install Server – Refer to the “Preparing to Install
Solaris Software Over the Network,” section of the Solaris Advanced
Installation Guide, available at http://docs.sun.com.
The basic steps to set up a boot and install server are as follows:
Step 1.
Insert the Solaris distribution CD in the boot/install server’s CD-
ROM drive.
Step 2.
Change your directory to the Tools area on the distribution CD:
cd /cdrom/cdrom0/Solaris_2.8/Tools
Step 3.
Use the setup_install_server script to copy the boot and
installation files to the boot/install server:
./setup_install_server /export/home/install
Installing the itmpt Driver on the Boot/Install Server – After you
have set up the network boot and install server, follow these steps to run
the
install.sh
script, using the
–n
parameter to copy the driver kit to
the boot server’s boot files:
Step 1.
Place the diskette in the floppy drive and execute the
volcheck
command to ensure the system sees the floppy.
Step 2.
Change the directory to the root of the floppy:
cd /floppy/floppy0
Step 3.
Execute the
install.sh
shell script to add the itmpt driver to
the boot installation area: