Table 4.1 error messages, Error messages – LSI 7202CP User Manual

Page 42

Advertising
background image

4-10

Solaris Software Requirements

Copyright © 2001, 2002 by LSI Logic Corporation. All rights reserved.

system assigns. This number helps to identify the bus that is reporting
the error.

Table 4.1

Error Messages

Error Messages

Explanation

itmpt<n>: This hardware not
supported by this driver.

itmpt has been told to control an MPT device that is made by a
manufacturer other than LSI Logic/IntraServer. This adapter
requires a special driver provided by that manufacturer. Please
contact the manufacturer for assistance.

itmpt<n>: Failed to map device
registers.

itmpt was unable to access the hardware registers necessary
for operation. The operating system did not properly configure
the PCI device. Make sure your adapter has LSI Logic Fcode,
and that the adapter is working correctly at the SUN Open Boot
PROM (OBP) prompt.

itmpt<n>: Hardware not properly
enabled by system, cmd=xxxxh.

The system has not properly enabled the configuration
resources that itmpt needs in order to use this hardware. The
cmd=xxxxh value must be reported to LSI Logic technical
support.

itmpt<n>: Could not allocate
memory to read configuration data.

The driver was unable to allocate memory required to process
the configuration data. This means that the configuration was
not properly determined. To fix this, you may need to manually
configure the driver using the itmpt.conf file.

itmpt<n>: Unable to make reset
notification callbacks.

The itmpt was unable to notify the target device driver of a bus
reset. The target driver may start to malfunction.

itmpt<n>: ddi_dma_unbind_handle:
failed

The operating system failed to respond to the named routine in
a known manner. This is a fatal error that is not recoverable.
Please report this error to technical support.

itmpt<n>: ddi_dma_numwin() failed.

itmpt<n>: ddi_dma_getwin() failed.

itmpt<n>: ddi_dma_alloc_handle:
xxh unknown/impossible.

itmpt<n>:
ddi_dma_buf_bind_handle:
DDI_DMA_INUSE impossible.

itmpt<n>:
ddi_dma_buf_bind_handle: xxh
unknown/impossible.

itmpt<n>: No KeyROM found.
Hardware contains no valid license.

The adapter is not a valid LSI Logic adapter licensed for use
with Solaris systems.

Advertising