Panasonic KW-WP1050E - Manual (Page 170)

Base Unit Settings
170 Helpline Tel. No.: U.K. 0844 844 3898
4
Configure the settings under the Routing Setting heading, then click [Add] to add a new
entry.
5
Click [Restart].
L
The base unit automatically restarts and the Top Menu is displayed.
Note:
L
To edit the setting:
1
Click the desired entry number in step 3.
2
Edit the items in the Routing Setting page.
3
Click [Save].
4
Click [Restart].
L
To delete the setting:
1
Click the desired entry number in step 3.
2
Click [Delete] in the Routing Setting page.
3
Click [OK] in the confirmation dialogue box.
4
Click [Restart].
L
This feature is not available in AP (Bridge) mode.
Setting Description
[Status]
L
Select whether to enable or disable the routing setting.
[Destination
Network/Mask] L Enter the network address/netmask for the destination IP
address.
L
If you want to set one IP address, enter that IP address in IP
address field and “32” in netmask field. (e.g. If you want to
control the packet from 192.168.1.1, enter “192.168.1.1” in IP
address field and “32” in netmask field.)
L
If you want to set a range of IP addresses, enter that network
address in IP address field and it’s netmask in netmask field.
(e.g. If you want to control the packet from 192.168.1.0 -
192.168.1.255, enter “192.168.1.0” in IP address field and
“24” in netmask field.)
[Gateway]
L
Enter the gateway IP address.
WP1050E.book Page 170 Thursday, March 29, 2007 11:31 AM