Panasonic KW-WP1050E - Manual (Page 189)

Base Unit Settings
Helpline Tel. No.: U.K. 0844 844 3898 189
Reset to Factory Default:
The base unit settings can be reset to the base unit’s factory default. See page 204 for the
default settings.
1
Click [Advanced Setup] on the Top Menu.
2
Click the [Maintenance] tab, then click [Reset to Factory Default].
3
Click [Reset to Factory Default] to reset the base unit settings.
L The confirmation message is displayed.
4
Click [OK] in the confirmation dialogue box.
L
The base unit begins to restart and the Top Menu is displayed.
Note:
L
In step 4, if the LAN side setting is changed or AP (Bridge) mode is used, the base unit
restart automatically, but the Top Menu is not displayed automatically.
You need to click to the link shown on the Restarting page to access to the Top Menu.
L You need to register the handset to the base unit again when you reset the base unit to
factory default.
See “Registering the handset” on page 136.
WP1050E.book Page 189 Thursday, March 29, 2007 11:31 AM