Panasonic KW-WP1050E - Manual (Page 45)

Getting Started
Helpline Tel. No.: U.K. 0844 844 3898 45
7
Select the desired connection mode used in the current mode (HOME or HOTEL), then
click [Next>].
When the Mode selector is set to “HOME”:
L
Internet connection modes vary according to the Internet service provider. Select a
connection mode referring to the Internet service provider's setup information.
L Select [DHCP], [Static] or [PPPoE] if the base unit is installed in Router mode.
L Select [AP (Bridge)] if the base unit is installed in AP (Bridge) mode.
Setting Description
[DHCP]
L
Allows the base unit to receive an IP address automatically
from a DHCP server. This connection mode is usually
required for use with cable modems. Select if you are
instructed to specify DHCP, host name and/or MTU value by
your Internet service provider. Otherwise, select [Default
settings] in step 6.
[Static]
L
Allows the base unit to assign a specific IP address.
[PPPoE]
L
Allows the base unit to receive an IP address from a PPPoE
server. This connection mode is usually required for use with
DSL modems.
[AP (Bridge)]
L
Allows the base unit to work as an access point when you
have a router at home.
WP1050E.book Page 45 Thursday, March 29, 2007 11:31 AM