Panasonic KW-WP1050E - Manual (Page 222)

Useful Information
222 Helpline Tel. No.: U.K. 0844 844 3898
Base unit Indicators:
Problem Cause/Solution
The WAN Indicator is
blinking in red.
L
The base unit hardware may be defective.
L Unplug the base unit’s AC adaptor. Reconnect the
adaptor and try again.
L
If this doesn’t resolve the problem, visit
http://www.panasonic.co.uk
Then enter model no. KX-WP1050.
The WAN Indicator is
blinking in amber. L The base unit firmware may be defective and requires
an update firmware (page 202).
The WAN Indicator is
amber.
L
An Internet connection has not yet to be established.
L
Check the Internet connection settings.
L
Check that you are required to register MAC address
(page 153).
L When you change the Internet connection device from
your existing router to the base unit, it may take time to
connect.
The WAN Indicator
alternately flashes in
amber and green in turn.
L
The networks on the WAN side and the LAN side
overlap. Change the LAN side network settings
(“Temporary LAN Side Network Setting when networks
on the WAN side and the LAN side overlap” on page
199).
The WAN Indicator
flashes as a short blinking
in amber and a long flash
in green in turn.
L
LAN side network setting is changed temporarily
(“Temporary LAN Side Network Setting when networks
on the WAN side and the LAN side overlap” on page
199).
The WAN Indicator is off. In the hotel room:
L
Check that the base unit and the Ethernet port (RJ45
socket) in the hotel room are connected properly.
L Check that the power of the base unit is turned on.
At home:
L
Check that the base unit and your device (modem,
existing router or modem with a build-in router) are
connected properly.
L
Check that the power of the base unit and your device
are turned on.
WP1050E.book Page 222 Thursday, March 29, 2007 11:31 AM