Panasonic WJ-DR200 - Manual (Page 27)

-25-
● Capture Rate
This item lets you specify the interval (seconds) for
recording of multiple freeze pictures.
1. Move the cursor to the CAPTURE RATE parameter
in the MANUAL REC ALARM menu by pressing the
or button.
2. Select the desired interval by pressing the or
button.
The following intervals are available depending on
the selected pixel number.
720 * 480: 0.07, 0.10, 0.17, 0.20, 0.33, 0.50, 1.0,
2.0, ····· 30.0
720 * 240: 0.03, 0.07, 0.10, 0.17, 0.20, 0.33, 0.50,
1.0, 2.0, ····· 30.0
The default setting is 0.20 sec.
4. Time Lapse Program Timer Setup
This menu lets you change the parameters of Time
Lapse Program Timer recording.
1. Move the cursor to the AUTO START parameter in
the TIME LAPSE menu by pressing the or
button.
2. Select T/L PROG.TIMER by pressing the or
button, then press the SET button. The TIME LAPSE
PROGRAM TIMER menu shown below appears on
the monitor screen.
TIME LAPSE PROGRAM TIMER
START END
Sun: OFF --:-- - --:--
Mon: OFF --:-- - --:--
Tue: OFF --:-- - --:--
Wed: OFF --:-- - --:--
Thu: OFF --:-- - --:--
Fri: OFF --:-- - --:--
Sat: OFF --:-- - --:--
Daily OFF --:-- - --:--
● Video Pixels (Resolution) Setup
This item lets you select the pixel number (number of
horizontal x vertical picture elements) or resolution of
the video picture.
1. Move the cursor to the VIDEO PIXEL parameter in
the MANUAL REC ALARM menu by pressing the
or button.
2. Select the desired mode by pressing the or
button.
720 * 480/3DIM ON: High resolution non-blur pic-
ture
720 * 480/3DIM OFF: High resolution picture
720 * 240: Lower resolution, but higher number
of frames.
The default setting is 720 * 480/3DIM ON.
Note: The parameter 720 * 240 is fixed if the A
(CAMERA ID ON) is selected for the CAMERA
INPUT parameter in the VIDEO INPUT menu.
● Video Quality (Compression Rate) Setup
This item lets you set the quality of the video picture by
selecting a compression rate.
1. Move the cursor to the VIDEO QUALITY parameter
in the MANUAL REC ALARM menu by pressing the
or button.
2. Select the desired mode by pressing the or
button.
FINE: For enhanced sharpness
NORMAL: For normal picture quality
ROUGH: For lower picture quality
The default setting is FINE.
● Audio Recording Setup
This item lets you enable or disable audio recording.
1. Move the cursor to the AUDIO RECORD parameter
in the MANUAL REC ALARM menu by pressing the
or button.
2. Select either ON or OFF by pressing the or
button.
ON: Enables audio recording.
OFF: Disables audio recording.
The default setting is OFF.
3. Move the cursor to the desired day of the week by
pressing the or button.
Sun-Sat: For setting the recording start and end
time separately for each day of the week.
Daily: For setting a uniform recording start and end
time for all days of the week.