Panasonic KX-NT700 - Manual (Page 31)

Making Calls
1. Confirm that the desired line ("IP" or "TEL") is
selected.
• You can change the selected line by pressing
the center function button ([F2]).
The IP line is selected. The TEL line is selected.
[F2] [F2]
• If you cannot select the desired line, change
the "Line Selection" setting (see page 30).
2. Press [ ].
3. For TEL calls: Enter the phone number.
For IP calls with IP-PBX connection: Enter the
phone number.
For IP calls with peer to peer connection: Enter
the IP address, then press [#] or [ENTER].
• IP addresses can be entered using the keypad.
[0]–[9] are used to enter numbers and [ ] is
used to enter a period. For example, to enter
"192.168.0.1", press [192 168 0 1].
• To temporarily use tone dialing when the line
mode is set to pulse mode, press [ ].
• After a call starts, the approximate length of the
call is shown on the display.
4. To end the call, press [ ].
Note
• To make a call using the phonebook, see
page 32.
• To make a call with a Portable Station (PS) or
computer connected to the unit, see page 41
or page 42.
• During the first 30 seconds of a TEL call, the unit
adjusts itself for optimal sound quality. Speak in
turns with the other party at the beginning of a
conversation. (The time required varies
depending on the condition of the telephone line
and the audio characteristics of the room.)
During this time, sound may cut out or fade in
and out. This is normal.
• If the unit is not connected to an IP network,
IP
is not displayed and the IP line cannot
be selected.
• The call length shown on the display is an
approximation and may differ from the actual
length of the call. Call charges accumulate after
the called party answers.
Adjusting the Speaker Volume
While on a call, press [ ] or [ ] repeatedly to adjust
the speaker volume. There are 8 levels of volume.
Quieter Louder
• If the other party has difficulty hearing you, press
[ ] to decrease the speaker volume. Your voice
heard by the other party will become louder.
Making a Call After Entering the
Phone Number or IP Address
1. Confirm that the desired line ("IP" or "TEL") is
selected.
• You can change the selected line by pressing
the center function button ([F2]).
The IP line is selected. The TEL line is selected.
[F2] [F2]
• If you cannot select the desired line, change
the "Line Selection" setting (see page 30).
2. For TEL calls: Enter the phone number.
For IP calls with IP-PBX connection: Enter the
phone number.
For IP calls with peer to peer connection: Enter
the IP address.
• If you make a mistake, press [ ], then enter
the correct phone number or IP address. To
erase all numbers, press and hold [
].
• If a pause is required when making a call on the
TEL line, press [REDIAL/PAUSE] between
digits as necessary.
3. Press [ ] or .
4. To end the call, press [ ].
Document Version 2008/10 Operating Instructions 31
Making and Answering Calls