Redialing, Entering dialing pauses, Making a call from the phonebook – Panasonic KX-NT700 User Manual

Page 32

Advertising
background image

Redialing

The last 10 calls made are stored in the redial list, in
order of newest to oldest call.

1.

Press [REDIAL/PAUSE].

The last call made is displayed.

2.

Press [ ] or [ ] repeatedly to scroll through the
list.

To erase the displayed item, press

ERASE

.

To exit the redial list, press [MENU].

3.

When the desired entry is displayed, press [

] or

.

Note

The line that was used to make each call in the
redial list ("IP" or "TEL") is shown in the
lower-right corner of the display. This line will be
used when the call is redialed.
Example:

The TEL line will
be used when you
redial this
number.

If the "Line Selection" setting is not set
to "IP + TEL" (see page 30), TEL line calls
cannot be redialed.

If the dialed number contains too many digits
(more than 32 digits for IP calls with IP-PBX
connection, more than 128 digits for TEL calls),
it cannot be redialed correctly.

Entering Dialing Pauses

A pause is sometimes required when making calls on
the TEL line using a PBX or a long distance service. For
example, if you must dial "9" before dialing an outside
phone number, you probably wait (pause) after
dialing "9" until you hear a dial tone.
By pressing the [REDIAL/PAUSE] button when dialing,
the unit will store the dialing pause along with the phone
number in the redial list. If you make a call from the
redial list later, the unit will dial the number wait for the
pre-programmed number of seconds (default: 3 s; see
page 49) for each dialing pause you entered.

Example:
1.

Press [9] (to access an outside line of a PBX).

2.

Press [REDIAL/PAUSE].

Press [REDIAL/PAUSE] repeatedly to create
longer pauses. An additional pause is inserted
each time [REDIAL/PAUSE] is pressed.

3.

Dial the phone number.

4.

Press [

] or

.

Making a Call from the Phonebook

See page 36 to add entries to the phonebook.

1.

Press

.

2.

Press [ ] or [ ] repeatedly to scroll through the
phonebook entries.

Entries are displayed in the following order
when [ ] is pressed.
Symbols

®Numbers®Letters

Press the dial key corresponding to the desired
character, then press [ ] or [ ] to scroll if
necessary.

To exit the phonebook, press [MENU].

3.

When the desired entry is displayed, press [

] or

.

Note

The line that was selected when the entry was
stored in the phonebook ("IP" or "TEL") is
shown in the lower-right corner of the display.
This line will be used when the entry is called.

Example:

The TEL line will
be used when you
call this number.

If the "Line Selection" setting is not set
to "IP + TEL" (see page 30), TEL line numbers
cannot be called.

32

Operating Instructions

Document Version 2008/10

Making and Answering Calls

Advertising