Using the barometer, About the measured altitude and, Atmospheric pressure – Panasonic DMC-TS4 User Manual

Page 128: P128), 1013hpa

Advertising
background image

GPS/Sensor

- 128 -

Applicable modes:

Using the barometer

With the current atmospheric pressure as a reference,
it is displayed on the graph within the range of

j10 hPa

to

_10 hPa.

(Atmospheric pressure out of range cannot be
displayed in details)

A 24 hours earlier
B Present
C Time periods for which history was not recorded (white

portion)

D Atmospheric pressure information in 90 minute intervals

•

The barometer is an indicator of changes between fine weather and rain.

–

When the atmospheric pressure rises: Weather tends to recover

–

When the atmospheric pressure drops: Weather tends to worsen

Note

•

In the following cases, atmospheric pressure is not recorded on the graph.

–

When [GPS Setting] is set to [ON], the battery is low, and the power is off

–

When [Airplane Mode] is set to [ON] and the power is off

–

When [Sensor Settings] is set to [OFF]

–

[Underwater]

•

When the displayable range (current atmospheric pressure of

j10 hPa to _10 hPa from the

reference pressure) is exceeded, the atmospheric pressure will not be displayed correctly.

∫ About the measured altitude and atmospheric pressure
•

Altitude value may show errors depending on the change in atmospheric pressure compared to
areas such as locations with altimeter reference signs. Perform frequently with [Adjust] in
[Altimeter].

•

Altitude announced onboard an airplane is measured using the atmospheric pressure
surrounding the airplane. It does not match the altitude actually measured inside the airplane.

•

Even if the unit is fixed at a constant altitude, the measured altitude may fluctuate due to the
effects of change in atmospheric pressure.
In coastal areas, the altitude changes by 1 m (3.3 feet) per 0.12 hPa.

•

Altitude and atmospheric pressure may not be measured
accurately in the following cases:

–

When there is a significant change in weather conditions
(Pressure and air temperature)

–

When there is a movement with a rapid change in altitude

–

When pressure is applied to the front or rear of this unit

¢1

–

When this unit is wet (after using underwater, etc.)

¢2

–

When closing the side door

¢2

¢1 Hold this unit as shown in the figure when measuring.
¢2 It will adapt to the ambient atmospheric pressure within a few minutes, and display correct

measurement values.

24H

24H

24H

0H

0H

0H

1013hPa

1013hPa

1013hPa

+10 hPa

-10 hPa

Advertising