Precor Low Impact 9.31 - Manual (Page 36)

Owner’s Manual: Advanced Programming and Troubleshooting 34
CAUTION: Precor recommends that you leave the
password protection enabled. And remember, do not
allow children or those unfamiliar with its operation on
or near the treadmill. Do not leave children
unsupervised around the unit.
7. Press SELECT to accept the displayed setting.
The change will be retained in memory even if the treadmill
is turned OFF and unplugged.
8. To end the programming mode and return to the Precor
banner, press RESET.
Informational Displays
The treadmill provides information about its use (odometer
and hour meter), as well as software version and error log. In
general, you would only access this information if directed to
do so by Precor Customer Support.
These instructions guide you through all four informational
displays. Pressing the SELECT key moves you through the
displays. To exit, press the RESET key at any time.
Viewing the Odometer
1. At the Precor banner, press the following keys in
sequence without pause:
RESET, SPEED ▼, SELECT
Numbers 6, 5 appear on the display as you press the
associated key.
Then MILES: scrolls across the display followed by the
odometer value (the cumulative miles users have traveled).
Note: If the unit of measure is set to metric, then
KILOMETERS: scrolls instead of MILES:.
2. When you are ready, press SELECT to move to the next
display (hour meter).