Printronix L1024 - Manual (Page 21)

2–3 Setting Up the Printer
•
Make sure nothing rests on the power cord. Do not locate the power cord
where people will walk on it. Do not place the power cord under any
carpet.
•
Do not lean or place heavy objects on top of the printer.
For additional requirements, refer to Appendix A.
Check the Power Requirements
WARNING
Do not connect the printer to the power source until instructed to do so
and until all shipping restraints have been removed.
WARNUNG
Den Drucker nur unter Anleitung an die Stromquelle anschließen, und
erst dann, wenn alle Versandmaterialien entfernt worden sind.
ATTENTION
A moins d’en avoir recu l’ordre, ne pas brancher l’imprimante avant
d’en avoir ôté tout le matériel d’emballage.
The printer must be connected to an acceptable AC power source; otherwise, the
printer will not operate properly and may be damaged. The rear side panel label
identifies the correct power source for the printer: either 100 to 120 VAC, 60 Hz
or 220 to 240 VAC, 50 Hz.
The power source must be properly grounded. Since large power fluctuations can
cause the printer to malfunction, it should be connected to a “noise–free” power
source, not subject to surges or noise generated by motors, lighting, or air
conditioning equipment on the same circuit. To allow for an adequate power
cable run, the printer should be placed no more than eight feet (2.5 meters) from
the power outlet.