Printronix L1024 - Manual (Page 56)

3–12 Configuring the Printer
e. Press DOWN.
f. Press NEXT or PREV to cycle through the options (1–8).
When the desired number is displayed (e.g., 1), press ENTER
to select it. The JOB IN PROCESS light flashes and the
following is displayed briefly:
STANDBY . . .
Then, the following is displayed to indicate the configuration is
being deleted:
Delete Config.
1 *
5. Save the new configuration as described on page 3–7. Make sure you
select the same number (e.g., Config. 1) when saving the modified
configuration. The new configuration replaces the existing one.
6. Print a copy of this newest configuration and store it in a safe place.
Refer to page 3–13 for details.
NOTE: If you want to make these new configuration parameters active at
printer power–up, make sure you select this configuration as the
“power–up config” (page 3–25).