Printronix L1024 - Manual (Page 54)

3–10 Configuring the Printer
Modifying a Configuration
You can change a saved configuration by “writing” over it. For example, you can
modify Config. 1, shown below. Suppose you want to keep all settings except the
interface type (e.g., you want to change RS–232 to Centronics). It is necessary to
load a configuration, make the desired changes, delete the current “copy” of the
configuration, and save the current machine configuration (in this example,
configuration 1 with the desired changes) as the newly modified configuration.
Config. 1: Selects RS–232 Serial Interface
Selects Image Width of 4 inches
Selects Paper Length of 24 inches
Selects Image Shift of 1 inch, etc.
1. Load the configuration to be changed (for example, Config. 1).
a. Press ON LINE to take the printer offline.
OFFLINE
PAPER CONTROL
b. Press NEXT or PREV until the following is displayed:
OFFLINE
DISK MANAGEMENT
c. Press DOWN.
d. Press NEXT or PREV until the following is displayed:
DISK MANAGEMENT
Load Config.
e. Press DOWN.
f. Press NEXT or PREV to cycle through the options (0–8).
NOTE: Configuration “0” is the factory default configuration and cannot be
altered.