Printronix LQH-HWTM - Manual (Page 17)

Modes of Operation
17
Table 1. Normal Mode Commands
Command Mnemonic Description Page #
Compressed Print DENSITY Defines the horizontal print density in characters per inch (cpi). 45
Configuration CONFIG Reconfigures IGP/PGL parameters 46
Create CREATE Places the IGP in the Create Form Mode where all the Create
Form Mode commands are available to design form elements. 51
Create Logo LOGO Places the IGP in the Create Logo Mode, where logos can be
defined using the appropriate dot placements. 76
Delete Form DELETE
FORM Deletes a selected form name from the directory and IGP
memory. 52
Directory DIRECTORY Provides a list of all defined forms and logos, logo assignments
to forms, and memory usage and availability. 53
Emulation Switch EMULATION Switch emulation from IGP/PGL to IGP/VGL (if VGL is present) 57
Execute EXECUTE Executes a previously created form. 58
Expanded Print EXPAND Expands fonts vertically and horizontally. 68
Font FONT Selects a specific typeface: bold, slant (italic) factor, and
symbol set. 69
Ignore Sequence
On/Off IGON
IGOFF Enables the IGP to ignore all characters after the Ignore
Sequence On command is sent until the Ignore Sequence Off
command is sent. See note on page 20. 71
Line Spacing,
Vertical LPI Defines the lines per inch (lpi) printing format. 71
Listen LISTEN Removes IGP from the quiet state and enables IGP operation. 74
Multinational
Character Set ISET
USET Use a character set.
Create a custom user-defined character set. Chap. 5
Normal Mode NORMAL Places the IGP in the Normal Mode, where it does not change
the data stream but awaits the SFCC followed by an IGP
command. 78
Paper Instruction
Enable/Disable EN-PI
DIS-PI Enables or disables use of the PI line with a parallel interface. 80
Paper Instruction
On/Off for Data Bit 8 PION
PIOFF Enables or disables Data Bit 8 as the paper instruction signal in
a serial interface. 79
Print File PRINT Prints a file from the flash memory. 80
Quiet QUIET IGP operation is disabled until a Listen command is received.
Any data sent to the line matrix printer emulation is unaffected
by IGP commands. 81
Recall RECALL Recalls forms or logos from memory stored in “setup.ptx”. 81
Reset RESET Deletes all forms and logos from the IGP memory. 82