Printronix LQH-HWTM - Manual (Page 62)

62
Chapter 2 Command Codes
Execute Form: Dynamic Alphanumeric Data
Purpose Incorporates the dynamic alphanumeric data into a previously
identified location on a form.
Mode EXECUTE
Format (cc)AF n; (D)ASCII text(D)
(cc) The Special Function Control Code.
AF n Indicates a dynamic alphanumeric field (AF) and its
data (
n). Enter AF and replace n with the number of
the data field corresponding to the number used to
identify the field when it was defined with the
Alphanumeric command in the Create Form mode.
(D) The printable character identifying the start and
finish of the alphanumeric data. Enter any printable
character other than a slash (/), the SFCC, or a
character used within the data. The same character
must be used at both ends of the data field but will
not be printed with the data.
ASCII text The group of ASCII characters (the alphanumeric
string) to print. Enter any of the standard ASCII
printable characters (except the character used as
delimiters described in the
(D) parameter). The
data appears on the form at the location identified
by the value of
n.
Comments The location for the dynamic alphanumeric data must have been
previously identified using the AF n;L parameters of the
alphanumerics command in the Create Form mode. Inputting
individual commands enters the new data into the identified
location each time the form is printed.
You can repeat the (cc)AF n;(D)ASCII text(D) sequence to
complete as many data fields as you defined on the form in the
Create Form mode. You can also combine the Execute Dynamic
Bar Code Data command in the same Execute command
sequence. Each “page” of dynamic data (the dynamic fields,
data, and overlay data) for the form must be separated from the
next page of new dynamic data by a form feed.
Note Be sure to enter Dynamic Alphanumeric Data after the
Execute command and/or EVFU data but before any
Overlay Data. (See the general Execute command format on
page 59.)