Printronix LQH-HWTM - Manual (Page 75)

Logo Call
75
SR Defines the starting row of the logo. The SR (and
SC) parameter specifies the location for the logo
based on the upper left corner of the grid in which
the logo was defined. Enter a value ranging from
row 1 through one less than the length of the form.
Character row or dot row is specified based on the
Scale command (page 83), or use the CP.DP
format (page 26).
SC Defines the starting column of the logo. The SC
(and SR) parameter specifies the location for the
logo based on the upper left corner of the grid in
which the logo was defined. Enter a value ranging
from column 1 through one less than the width of
the form. Character column or dot column is
specified based on the Scale command (page 83),
or use the CP.DP format (page 26).
logoname Identifies a previously defined logo by name for use
on the form. Enter the logo name exactly as used to
define and store the logo.
DISK Optional parameter to retrieve logo from the flash
memory. Enter DISK.
STOP Stop indicates the end of the LOGO command;
enter STOP, and the IGP will wait for a new
command. If not entered, the IGP expects another
set of Logo Call command parameters.
Example The following sample program specifies three logo calls placing
the same logo at three different locations. (The logo was
previously defined and stored.) The starting row and column
specify the upper left corner of the grid in which the logo was
defined. To illustrate positioning, the starting row and column are
indicated on the example but do not necessarily reflect actual
location on the page.
LOGO
56;35;HAND
56;50;HAND
56;65;HAND
STOP
logocall.e
SR 56
SC 35 SC 50 SC 65
Note When the logo to be executed is not found in memory, the
“LOGO NOT FOUND” error is printed.