Printronix LQH-HWTM - Manual (Page 57)

Emulation Switching
57
Emulation Switching
Purpose To switch the active emulation from PGL to the emulation
selected.
Mode NORMAL
Format (cc)EMULATION; emulation
EMULATION The Emulation Switch command.
emulation Specifies the emulation to activate. Currently, the
only selection is VGL (Code V). Enter VGL. If VGL
is not the selection, this command is then ignored.
Comments This command is only processed when VGL is included in the
software package. If not, this command is simply ignored. The
switching of emulations causes PGL to perform a soft reset.
Therefore, front panel selections return to their saved state, and
all forms and logos resident in RAM memory are deleted.
End
Purpose Terminates the current mode of operation and must be used
before entering a new mode command (EXECUTE, LOGO,
NORMAL, or even CREATE).
Mode CREATE
Format END
Comments After the End command is received, the IGP flushes program
errors, stores the error-free portions of the form program just
completed, and then returns to the Normal mode. If the debug
slash (/) is included in the Create command, the program prints
with any corresponding error messages.