Printronix LQH-HWTM - Manual (Page 72)

72
Chapter 2 Command Codes
Lines, Horizontal
Purpose Defines horizontal lines.
Mode CREATE
Format HORZ
LT; R; SC; EC
STOP
HORZ The Horizontal Line command; enter HORZ.
LT Defines the line thickness, measured in 1/72-inch
dots. Enter a value of 1 or greater. Horizontal line
thickness expands downward from the given row.
R Defines the row to draw the horizontal line. Enter a
value ranging from row 1 through one less than the
length of the form. Character row or dot row is
specified based on the Scale command (page 83),
or use the CP.DP format (page 26).
SC Defines the starting column of the horizontal line.
Enter a value ranging from column 1 through one
less than the width of the form. Character column
or dot column is specified based on the Scale
command (page 83), or use the CP.DP format
(page 26).
EC Defines the ending column of the horizontal line.
Enter a value ranging from column 2 through the
last column of the form. The ending column must
be greater than the starting column. Character
column or dot column is specified based on the
Scale command (page 83), or use the CP.DP
format (page 26).
STOP Stop indicates the end of the HORZ command;
enter STOP. If not entered, the IGP expects
another set of Horizontal Line command
parameters.
Example The following example specifies 2 horizontal lines. The first line
uses the character row in the R parameter, and the second line
uses CP.DP format. To illustrate positioning, the starting row and
column are indicated on the example but do not necessarily
reflect actual location on the page.
HORZ
1;60;15;65
1;60.5;15;65
STOP
COLUMN 15
ROW 60
COLUMN 65
ROW 60.5