POLAR S720i - Manual (Page 11)

A 9
Installing the Polar Bike Mount
Use cable ties to secure the bike mount
snugly on the rubber pad.
Attach the receiver by securing the wrist
strap.
Installing the Polar Speed Sensor™
The Polar Speed Sensor measures speed
and distance when cycling.
1. Check the front side of the front
fork to find a suitable place for the
speed sensor. The sensor should be
attached less than 50 cm/ 1’8" from the
mounted wrist receiver. The smaller the
distance the better. Clean and dry the
area underneath the rubber pad before
you attach it to the front fork.
2. Place the sensor in the position as in
illustration 2. Then adjust the sensor
towards the wheel as much as possible.
3. Pass the cable ties through the
sensor holes and loosely adjust the
ties. Do not tighten fully yet.
If the cable ties are too short for
your bicycle, put two of them
together to make them longer.
60
°
Riding dir
ection
max 50 cm /
1´8´´
1
2