Advanced tab field descriptions – Perle Systems 5500161-40 User Manual
Page 166
Serial Port Profiles
166
IOLAN SDS/SCS/STS/MDC User’s Guide, Version 4.0
Advanced Tab Field Descriptions
Configure the following parameters:
Success String
String that is sent to the serial device when a connection succeeds.
Default: CONNECT <speed>, for example,
CONNECT 9600
Failure String
String that is sent to the serial device when a connection fails.
Default: NO CARRIER
Numeric Codes
When enabled, the connection status is sent to the connected device using the
following numeric codes:
z
0 OK
z
1 CONNECTED
z
2 RING
z
3 NO CARRIER
z
4 ERROR
z
6 ITERFACE DOWN
z
7 CONNECTION REFUSED
z
8 NO LISTNER
Default: Enabled
Echo characters in
command mode
When enabled, echoes back characters that are typed in (equivalent to
ATE0/ATE1 commands).
Default: Disabled
DTR Signal Always
On
Specify this option to make the DTR signal always act as a DTR signal.
Default: Enabled
DTR Signal Acts as
DCD
Specify this option to make the DTR signal always act as a DCD signal.
Default: Disabled