Perle Systems 5500161-40 User Manual
Page 97
97
IP Settings
Monitoring Interval
x
(SCS only) The interval in which the active interface is checked to see if it is
still communicating.
Default: 100 ms
Recovery Delay
(SCS only) The time that the IOLAN will wait to make the secondary interface
(Ethernet 2) active after it has been detected as up.
Default: 200 ms
Enable IPv6 Router
Advertisement
When enabled, the IOLAN will periodically send IPV6 Router Advertisement
messages and respond to Router Solicitation messages. The Router
Advertisement message can be configured to contain any of the following
information:
z
DHCPv6—Use the DHCPv6 server to obtain additional IPV6 address(es)
and configuration parameters.
z
DHCPv6 Configuration Options—Use DHCPv6 server to obtain
additional configuration parameters.
z
Network Prefixes—Advertise the selected custom configured network
prefixes.
Default: Disabled
Advertise DHCPv6 When enabled, the Router Advertisement message indicates to use the
DHCPv6 server for obtaining additional IPv6 addresses and configuration
parameters.
Default: Disabled
Advertise DHCPv6
Configuration
Options
When enabled, the Router Advertisement message indicates to use the
DHCPv6 server to obtain additional configuration parameters.
Default: Disabled
Advertise the
following Network
Prefix(es)
The network prefix of the IPV6 addresses created in the
IPv6 Settings
tab in
the
Custom IPv6 Address List
are included in the Router Advertisement
message. You can choose to enabled or disable specific network prefixes from
being advertised to hosts.
Default: Enabled
Interface 1
Hardware Speed
and Duplex
Define the Ethernet connection speed (desktop models can support up to 100
Mbps and rack mount and medical unit models can support up to 1000 Mbps).
Data Options:
z
Auto
—automatically detects the Ethernet interface speed and duplex
z
10 Mbps Half Duplex
z
10 Mbps Full Duplex
z
100 Mbps Half Duplex
z
100 Mbps Full Duplex
z
1000 Mbps Full Duplex
Default: Auto
Interface 2
Hardware Speed
and Duplex
Define the Ethernet connection speed (available on SCS models only).
Data Options:
z
Auto
—automatically detects the Ethernet interface speed and duplex
z
10 Mbps Half Duplex
z
10 Mbps Full Duplex
z
100 Mbps Half Duplex
z
100 Mbps Full Duplex
z
1000 Mbps Full Duplex
Default: Auto