Panasonic PT-AX100E - Manual (Page 13)

About Your Projector
E
NGLISH
- 13
Preparation
J Back and bottom view
NOTE:
Do not cover the ventilation openings or place anything within 10 cm (4") of the vents as this may cause
damage or injury.
This projector should only be used with the attached Mains lead to ensure optimum performance and avoid
damage to the projector.
Connect an RS-232C
compatible cable for
controlling the projector
remotely via your PC.
SERIAL
Connect an RGB signal cable
from your PC.
PC IN
Connect a YP B P R signal
cable.
COMPONENT IN
Connect a S-VIDEO signal
cable.
S-VIDEO IN
Connect an HDMI signal
cable.
HDMI IN
Security lock
Lamp unit component
Houses the replaceable lamp
unit. Contact the projector
dealer or an authorised
service centre for
replacement. (page 37)
Front leg adjuster (L/R)
Screw up/down to adjust the
projection angle. (page 15)
COMPONENT IN
VIDEO IN
Connect an RCA composite
video cable.
AC IN
Connect the Mains lead to
supply electronic power to the
projector. (page 26)
MAIN POWER
Switch the projector on/off.
(page 19)
Connecting
terminals
Air intake port
Intake fresh air to control the
temperature inside.
Attach the commercial shackle
lock, manufactured by
Kensington, to protect your
projector. Compatible with the
Kesington MicroSaver
Security System.