Panasonic PT-AX100E - Manual (Page 29)

PICTURE Menu
E
NGLISH
- 29
Settings
You can adjust the skin tone in the projected image.
Setting range: -32 to +32
When PC is connected, this function is available with
1 125 (1 080)/60i, 1 125 (1 080)/50i,
1 125 (1 080)/60p and 1 125 (1 080)/50p signals
only.
You can adjust the sharpness of the projected image.
Setting range is vary according to the selected input
signal
You can adjust the white balance of the projected
image.
Setting range: -6 to +6
You can switch automatic adjustment of the lamp and
the lens iris on/off.
• ON: Automatic adjustment
• OFF: No adjustment
LUMINANCE SENSOR detects the brightness of the
room and keeps the luminance in balance
automatically. If needed, you can switch on/off this
function or adjust it manually. Press I H to cycle
through the options.
• OFF No adjustment
• AUTO: Automatic adjustment
• MANUAL: Manual adjustment (0 - +8)
From the ADVANCED MENU, you can perform more
detailed image adjustment manually.
J GAMMA
You can adjust linear intensity at 3 levels. Press
I H to increase/decrease.
Setting range: -8 to +8
J CONTRAST
You can adjust the amount of contrast in RGB
colours individually. Press I H to
increase/decrease.
Setting range: -16 to +16
J BRIGHTNESS
You can adjust the brightness in RGB colours
individually. Press I H to increase/decrease.
Setting range: -16 to +16
J COLOUR MANAGEMENT
You can manage your own defined colour settings.
See “Setting your own colour profile” on page 24.
TINT
SHARPNESS
COLOUR TEMPERATURE
DYNAMIC IRIS
LIGHT HARMONIZER
More
reddish
More
greenish
More
sharp
Less
sharp
Less
reddish
Less
bluish
LIGHT HARMONIZER
MODE
MANUAL ADJUST
AUTO
NOTE:
To assure correct performance of the LIGHT
HARMONIZER, do not interrupt the light onto the
LUMINANCE SENSOR.
ADVANCED MENU
Levels Default setting
GAMMA HIGH 0
GAMMA MID 0
GAMMA LOW 0
RGB Default setting
CONTRAST R 0
CONTRAST G 0
CONTRAST B 0
RGB Default setting
BRIGHTNESS R 0
BRIGHTNESS G 0
BRIGHTNESS B 0