Panasonic PT-AX100E - Manual (Page 25)

Remote control operation
E
NGLISH
- 25
Basic Operation
4. Press ENTER to store the adjusted result.
“PROCESSING” is displayed for a few seconds
and the result is stored in LOG.
You can store up to 8 logs under LOG for each
PICTURE MODE setting.
5. Press MENU or RETURN to return to the
previous menu.
Repeat the steps above to store more
adjustment.
Q Managing stored logs
You can edit or delete the stored logs of the
selected PICTURE MODE.
1. Select LOG and press ENTER.
The LOG menu is displayed.
2. Select the required log from 1 - 8 or ALL
DELETE, and press ENTER.
Select CHANGE to edit the log.
The cursor menu is displayed and you can
readjust the colour.
Select DELETE to delete the log.
The confirmation screen will be displayed.
Select OK to delete.
When you select ALL DELETE, the "DELETE
ALL LOG." screen is displayed. Select OK to
delete all logs. The PROFILE setting will be set
to NORMAL.
Q Saving a log setting as a profile
Return to the COLOUR MANAGEMENT menu
and save the stored log as a profile. Make sure that
the PICTURE MODE is not switched.
1. Select the PROFILE SAVE menu and press
ENTER
The PROFILE SAVE menu is displayed. You
can save the profile as USER1, USER2 and
USER3.
2. Press ENTER to save the profile
The confirmation screen is displayed. Press
ENTER again to save.
J Loading saved profiles
When profiles are loaded under the PICTURE
MODE setting, you can keep them as you defined
until the PROFILE is set to NORMAL.
1. Select the required PICTURE MODE and
press ENTER.
2. Press the COLOR MANAGEMENT button
and select the PROFILE menu.
The profile settings of the selected PICTURE
MODE will be displayed.
3. Select the required profile and press ENTER.
COLOUR
Adjust the vividness of the colour.
Setting range: -30 to +30
Default: 0
TINT
Adjust the colour tone.
Setting range: -30 to +30
Default: 0
BRIGHTNES
S
Adjust the brightness of the colour.
Setting range: -20 to +20
Default: 0
PICTURE MODE : CINEMA1
POINT1
POINT2
POINT3
POINT4
POINT5
POINT6
POINT7
POINT8
ALL DELETE
Sampled colour Adjusted colour
NORMAL
Return to the default setting of the
PICTURE MODE
USER1
Defined profile settings. USER2
USER3
NOTE:
LOG and PROFILE SAVE are not displayed
before you apply COLOUR MANAGEMENT.
If you load a profile with a different attribute mode
of the profile, the CURSOR and PROFILE SAVE
menus will not be displayed.
The approximate colours will be adjusted at the
same time. If you adjust the exact same colour
differently, both colours will affect each other and
you might get unexpected results.
White, Black and Grey are not adjustable.
If you escape the COLOUR MANAGEMENT
menu or attempt to perform another menu action
before you save the adjusted profile, the
confirmation screen will be displayed.
If you switch the input signal before you save the
profile, the setting will be cancelled without notice.
USER3
USER2
USER1