Paradyne 3161-B3 - Manual (Page 240)

E. SNMP MIB Objects
E-26 February 2001 3160-A2-GB21-90
Where these object identifiers are defined as follows:
T testLoopDTLB – OBJECT IDENTIFIER ::= [wellKnownTests 2]
T testMonQRSS – OBJECT IDENTIFIER ::= [wellKnownTests 3]
T testMon511 – OBJECT IDENTIFIER ::= [wellKnownTests 4]
T testSendQRSS – OBJECT IDENTIFIER ::= [wellKnownTests 5]
T testSend511 – OBJECT IDENTIFIER ::= [wellKnownTests 6]
T testSendV54Up – OBJECT IDENTIFIER ::= [wellKnownTests 7]
T testSendV54Down – OBJECT IDENTIFIER ::= [wellKnownTests 8]
T testSendFT1Up – OBJECT IDENTIFIER ::= [wellKnownTests 9]
T testSendFT1Down – OBJECT IDENTIFIER ::= [wellKnownTests 10]
Generic Interface Test Table – “ifExtnsTestResult” Object
(ifExtnsTestEntry 5)
This object contains the result of the most recently requested test. Only the
following values are supported by the DSU/CSU.
T none(1) – No test currently active.
T inProgress(3) – A test is currently in progress.
T notSupported(4) – The requested test is not supported.
T unAbleToRun(5) – The requested test cannot run due to the state of the unit.
Generic Interface Test Table – “ifExtnsTestCode” Object
(ifExtnsTestEntry 6)
This object contains a code that contains more specific information on the test
result. This object is defined as an object identifier. Only the following values are
supported by the DSU/CSU.
T none – No further information is available. Used for the send pattern/code and
loopback tests.
T inSyncNoBitErrors – A monitor pattern (QRSS or 511) test has synchronized
on the pattern and has not detected any bit errors.
T inSyncWithBitErrors – A monitor pattern (QRSS or 511) test has synchronized
on the pattern and has detected bit errors.
T notInSync – A monitor pattern (QRSS or 511) test has not synchronized on
the requested pattern.