Paradyne 3161-B3 - Manual (Page 61)

3. Operation
3160-A2-GB21-90 February 2001 3-27
7. Press F2 (Enab) to enable trap messages over the SNMP management link.
Selecting the Number of Trap Managers
If you intend to issue traps to an SNMP manager(s) from this device, you must
specify the number of SNMP managers that are to receive the traps.
Procedure
To specify the number of SNMP managers to receive traps from this device:
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied into the Edit area by using the
appropriate Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the key until the Mgmt selection appears on
the screen.
5. Select Mgmt.
6. From the Mgmt Config screen, select Trap.
7. Select the number of SNMP managers to receive traps (from 1 through 6) by
using the appropriate Function key. Use the scroll keys, if necessary.
F1 F2 F3
SNMP Trap:
Next Enab Disab
F1 F2 F3
Edit:
User Alarm Mgmt
F1 F2 F3
Mgmt Config:
Gen Trap
F1 F2 F3
Num Trap Mgrs:1
Next 1 2