Procedure – Paradyne 3161-B3 User Manual

Page 93

Advertising
background image

3. Operation

3160-A2-GB21-90

February 2001

3-59

Initiating a Call for PC, ASCII Terminal/Printer, or SNMP Operation

Use the Dial command to set up a semipermanent connection to route alarm
messages to the specified destination. The Dial command initiates a call through
the integral modem to a printer, ASCII terminal, or PC.

Procedure

To initiate a call at the local DSU/CSU:

1. From the top-level menu screen, press the

key until the Ctrl selection

appears on the screen.

2. Select Ctrl.

3. From the Control screen, select Call.

4. From the Call Setup screen, select Dial. This selection is not available if the

DSU/CSU’s integral modem is already in use.

5. From the Dial Directory screen, press F1 (Up) to display the next higher

numbered directory or press F2 (Down) to select the next lower numbered
directory.

6. When the number of the desired directory appears on the screen, press F3

(Dial) to place the call.

F1

F2

F3

Control:
Call Rel LED

F1

F2

F3

Call Setup:
Pass Dial ChDir

F1

F2

F3

Dial

n: xxxxxxxxx

Up Down Dial

F1

F2

F3

Dial

n: xxxxxxxxx

Up Down Dial

Advertising
This manual is related to the following products: