Paradyne 3161-B3 - Manual (Page 76)

3. Operation
3-42 February 2001 3160-A2-GB21-90
4. Line 1 displays the 24 channels for the network interface or the DTE
Drop/Insert (DSX-1) interface, depending on which destination was chosen.
This example assumes that the network is the destination. Line 2 displays
what is allocated to the DS0 channel shown in Line 1. Pressing the
or
key scrolls the channels onto the screen in groups of three. Select the channel
by pressing the Function key under the desired number. Portn appears. The
port is assigned to that channel. To deallocate a port, press the Function key
under that port number. Pressing the Function key under channels assigned to
other ports has no effect.
Allocating DS0 Channels from the DTE Drop/Insert Interface to the Network Interface
By using the configuration options, you can allocate DS0 channels from the DTE
Drop/Insert (DSX-1) interface to the network interface and specify which DS0
channels carry Robbed Bit Signaling (RBS) information for voice channels.
Procedure
To allocate DS0 channels from the DTE Drop/Insert (DSX-1) interface to the
network interface:
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied into the Edit area by using the
appropriate Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the key until the Chan selection appears on
the screen.
5. Select Chan.
6. From the Channel Config screen, select DTE.
F1 F2 F3
N1 N2
Next Prt1 Prt2
F1 F2 F3
Edit:
Port NET Chan
F1 F2 F3
Channel Config:
Dsply Clear DTE