Panasonic AJ-HDC27V - Manual (Page 15)

15
Shooting (recording)/playback
function section (3)
7 SHUTTER switch
This is set to ON when the electronic shutter is to
be used. When the SEL side is pressed, the
shutter speed and mode display are changed in the
range which was set ahead of time in the setting
menu.
If this switch setting is changed while the display
mode is set to “2” or “3,” the new setting will appear
at the shutter display position on the viewfinder
screen.
(Example: “: 1/120”, “: 50%”)
8
ECU REMOTE (remote control) connector (6-
pin)
The AJ-EC3 extension control unit (optional
accessory) is connected here.
<Note>
Before connecting or disconnecting the remote
control cable, be absolutely sure to set the POWER
switches on the unit and extension control unit to
the OFF position.
9 HD SDI OUT connector (BNC)
The HD SDI signals (video and audio) for the
monitor in accord with the position of the MONITOR
OUT SDI switch
:
are output from here.
When the SDI switch is at “EE/PB,” the EE video
and EE audio signals will be output during
recording and the playback video and playback
audio signals will be output during playback.
When the SDI switch is at “EE,” the camera video
signals are output at all times.
When the CHARACTER switch is set to ON while
performing the menu settings, it is possible to
superimpose the setting menus onto the pictures
being shot so that they can be checked on the
monitor screen.
The user’s bit is also output from the HD SDI OUT
connector.
The active frame information is output in the least
significant digit of the user’s bit while the frame rate
information is output in its lower third and fourth
digits.
<Note>
In order for the time code that matches the
playback time code, which is output from the HD
SDI OUT connector, to be output from the TC OUT
connector, set the SDI switch to “EE/PB,” and
select “TCG/TCR” as the TC OUT item setting on
the TC/UB screen.
Parts and their functions
9
7 9
8