Panasonic AJ-HDC27V - Manual (Page 86)

86
VF DISPLAY screen
The information to be displayed inside the viewfinder
is set on this screen.
Item
Variable
range
Remarks
DISP
CONDITION NORMAL
HOLD
VF
display
USER
ENG NORMAL:
The statuses are
displayed at all times.
HOLD:
The statuses are
displayed when MODE
CHECK SW is ON.
DISP MODE 1
2
3 USER
ENG
VF OUT Y
NAM
R
G
B USER
ENG For selecting VF OUT.
NAM (N Additive Mix):
The signal with the highest
level among the R, G and
B signals is output.
VF DTL 0
:
4
USER
ENG For selecting VF DTL.
The detail of the signals
for VF is further boosted.
At the “0” setting, the
detail is the same as the
unit’s.
ZEBRA1
DETECT 50%
:
70%
:
110%
USER
ENG For setting the ZEBRA1
detection level (IRE level).
ZEBRA2
DETECT 50%
:
85%
:
110%
USER
ENG For setting the ZEBRA2
detection level (IRE level).
ZEBRA2 ON
OFF
SPOT USER
ENG For setting ZEBRA2 to ON
or OFF and selecting
SPOT.
<Note>
When used at the “SPOT”
setting, ensure that the
ZEBRA2 DETECT value is
set higher than the
ZEBRA1 DETECT value.
If the ZEBRA2 DETECT
value is lower than the
ZEBRA1 DETECT value,
the ZEBRA display will not
appear.
The underlining in the variable range column indicates the setting in the preset mode.
Setting menu screens
(CAM MAIN MENU 2)
Change
Display
1 2 3
t t ± FILTER
t t ± GAIN
t t ± AWB
t ± ± AUTO KNEE SW
t ± ± SHUTTER
t ± ± ABB STATUS
t ± ± AWB STATUS
VF MARKER screen
The information to be displayed inside the viewfinder
is set on this screen.
Item
Variable
range
Remarks
SAFETY ZONE OFF
:
3
:
12
VF
display
USER
ENG For selecting the safety
zone display.
1 : 80% and 90% corner
display
2 : 80% corner display
3 : 90% corner display
4 : 80% and 90% box
display
5 : 80% box display
6 : 90% box display
7 : 80% and 90% corner
display in 4:3 mode
8 : 80% corner display in
4:3 mode
9 : 90% corner display in
4:3 mode
10 : 80% and 90% box
display in 4:3 mode
11 : 80% box display in
4:3 mode
12 : 90% box display in
4:3 mode
CENTER MARK ON
OFF USER
ENG For setting the center
marker display to ON or
OFF.
Item
Variable
range
Remarks
VF
display
LOW LIGHT LVL OFF
20%
25%
:
40%
45%
USER
ENG For selecting the light level
for the LOW LIGHT
display when the amount
of light entering the
camera is too low.
FRAME SIG 4 : 3
13 : 9
14 : 9 USER
ENG For selecting the frame
marker display.
MARK ON
OFF USER
ENG For setting the frame
marker display to ON or
OFF.
LVL 0
:
15
USER
ENG For setting the picture
levels on the outside of
the frame marker.