Precor EFX 5.25 - Manual (Page 41)

Owner’s Manual: Advanced Programming and Troubleshooting 39
Selecting a U.S. Standard or Metric
Display
The EFX can display measurements in either metric or U.S.
standard. The default factory setting is set to display U.S.
standard. To change this setting, perform the following
steps:
1. At the Precor banner, press and hold ENTER while
pressing the following keys in sequence without pause:
RESET, CROSSRAMP ▼, RESISTANCE ▲
Use the arrow keys to select a unit of measure (either
METRIC or U.S.).
2. When you are ready, press ENTER to accept the
displayed setting. The display indicates the setting is
saved. Press RESET to return to the Precor banner.
Note: Changing the display to metric measurements
affects the default settings. Distances and the
odometer values are converted to and appear in
kilometers (KM). Speed appears in kilometers per hour.
Viewing the Software Part Numbers,
Odometer, and Hour Meter
The EFX stores the total number of strides and the total
number of hours the unit has been in use. You can view this
information by performing the following steps:
1. At the Precor banner, press and hold ENTER while
pressing the following keys in sequence without pause:
RESET, CROSSRAMP ▲, RESISTANCE ▼
The software part numbers scroll across the center
display while the odometer and hour meter scroll
across the lower display.
2. Write the software part numbers below. You will need
these numbers if you call Customer Support with
questions. This information will help rule out any
software-related problems:
UPPER: ___________________
LOWER: ___________________
3. When you are ready, press RESET to return to the
Precor banner.
52x-V_Owners Manual.book Page 39 Monday, June 2, 2008 4:09 PM