National Instruments NI PXIe-1075 - Manual (Page 27)

Chapter 2 Installation and Configuration
© National Instruments Corporation 2-7 NI PXIe-1075 User Manual
3. Install the system controller into the system controller slot (slot 1,
indicated by the red card guides) by first placing the system controller
PCB into the front of the card guides (top and bottom). Slide the
system controller to the rear of the chassis, making sure that the
injector/ejector handle is pushed down as shown in Figure 2-3.
Figure 2-3. Installing a PXIe System Controller
4. When you begin to feel resistance, pull up on the injector/ejector
handle to seat the system controller fully into the chassis frame. Secure
the system controller front panel to the chassis using the system
controller front-panel mounting screws.
5. Connect the keyboard, mouse, and monitor to the appropriate
connectors. Connect devices to ports as required by your system
configuration.
6. Power on the chassis. Verify that the system controller boots. If the
system controller does not boot, refer to your system controller user
manual.
1 NI PXI Express System Controller
2 NI PXIe-1075 Chassis
3 Injector/Ejector Handle
4 System Controller Front Panel Mounting Screws (4x)
3
1
4
2
NI
PXIe-1
075