NetComm HS960 - Manual (Page 9)

YML857 Rev1 HS960 Wireless Gateway User Guide
www.netcomm.com.au 9
1-4-2 Rear Panel
The rear panel of the HS960 is shown below.
1. LAN (1-4):
The rear panel supports four auto-sensing RJ-45 ports and all ports can be auto-switched to MDI-II
connections. The LAN ports are used for linking hosts or other network devices. The individual port can be
either connected to 100BaseTX networks or 10BaseT networks. When connecting to a 100BaseTX network,
the ports operate at 100Mbps in half-duplex mode or 200Mbps in full-duplex mode. When connecting to a
10BaseT network, the ports operate at 10Mbps in half-duplex mode or 20Mbps in full-duplex mode.
2. WAN
One Ethernet port used for linking xDSL or Cable Modem.
3. Reset Button:
The HS960 has a reset button at the rear panel of the device. Use this function to reset the system back to
factory defaults.
4. Power Jack
Used to connect the external power supply with the HS960.
1 2 3 4