Nortel Networks CALLPILOT 555-7101-215 - Manual (Page 46)

Installing the server and connecting the peripheral devices Standard 1.0
46 CallPilot
Connecting the server to the ELAN
Introduction
Connect the CallPilot server to the Meridian 1 switch or Succession
CSE 1000 system using the Embedded LAN (ELAN).
Media Access Control address
The Media Access Control (MAC) address is a unique number assigned to
network cards and controllers. The procedure below asks you to record the
MAC address from the label affixed to the ELAN network card faceplate.
The network card faceplate is visible through the slot openings in the back
of the chassis.
To connect the server to the ELAN
1 See the diagram on page 44 to locate the on-board network card
connector. This is the ELAN connector.
2 Locate the label on the ELAN network card faceplate that identifies the
ELAN controller’s MAC address.
Note: This label is affixed to the chassis rear panel.
3 Record the MAC address on the Configuration Wizard worksheet that is
provided in Part 1 of the CallPilot Installation and Configuration binder.
You need the MAC address to identify the ELAN when running the
Configuration Wizard to configure the CallPilot server.
ATTENTION
For important considerations about using the ELAN in
your network, see “About the ELAN” in Part 1 of the
CallPilot Installation and Configuration binder.