NETGEAR ProSafe FVS124G - Manual (Page 123)

Reference Manual for the ProSafe VPN Firewall 25 with 4 Gigabit LAN and Dual WAN Ports
Virtual Private Networking 7-11
202-10085-01, March 2005
8. Enter the LAN IP address and subnet mask of the remote FVX538.
Figure 7-13: LAN IP address and subnet mask of remote FVX538
9. Click Next.
10. Click Done to create the 'to_fvx' IKE and VPN policies.
Testing the Connection
1. From a PC on either firewall's LAN, try to ping a PC on the other firewall's LAN. Establishing
the VPN connection may take several seconds.
2. For additional status and troubleshooting information, view the VPN log and status menu in
the FVX538 or FVS124G.
Creating a VPN Connection: Netgear VPN Client to FVS124G
This section describes how to configure a VPN connection between a Windows PC and the
FVS124G VPN Firewall.
Using the FVS124G's VPN Wizard, we will create a single set of policies (IKE and VPN) that will
allow up to 50 remote PCs to connect from locations in which their IP addresses are unknown in
advance. The PCs may be directly connected to the Internet or may be behind NAT routers. If more
PCs are to be connected, an additional policy or policies must be created.
Each PC will use Netgear's VPN Client. Since the PC's IP address is assumed to be unknown, the
PC must always be the Initiator of the connection.